Info: 2024-4-15 18:03:11 – (详细) sof2flash: Starting
Info: 2024-4-15 18:03:14 – (详细) sof2flash: Done
Info: Using cable “USB-Blaster [USB-0]”, device 1, instance 0x00
Info: Resetting and pausing target processor:
Info: OK
Info: Reading System ID at address 0x00211100:
Info:
Info: ID value verified
Info: Timestamp value was not verified: value was not specified
Info: No CFI table found at address 0x00000000
Info: Original contents (after writing 0xF0 and 0xFF00FF to address 0x00000000):
Info: 0: F0 FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 10: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 20: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: Contents after writing 0x980098 to address 0x000000AA:
Info: Same after writing 0x980098 to address 0x00000154:
Info: Same after writing 0x00980098 to address 0x000002A8:
Info: Same after writing 0x980098 to address 0x00000055:
Info: Same after writing 0x980098 to address 0x000000AA:
Info: Same after writing 0x00980098 to address 0x00000154:
Info: Same after writing 0x980098 to address 0x00000154:
Info: Same after writing 0x980098 to address 0x000002A8:
Info: Same after writing 0x00980098 to address 0x00000550:
Info: 0: F0 FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 10: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 20: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: 40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF …………….
Info: Leaving target processor paused
Error: Error code: 8 for command: nios2-flash-programmer “E:/update_doc/nios_test_update/qsys/hardware/flash/nios_test3_epcq_controller_avl_mem.flash” –base=0x0 –sidp=0x211100 –id=0x0 –accept-bad-sysid –device=1 –instance=0 ‘–cable=USB-Blaster on localhost [USB-0]’ –program –verbose